Manual-en:command info

From twidunode wiki
Jump to: navigation, search

info command

shell/terminal informative command.

"info" command manual

From terminal prompt It is possible to digit :

info [enter]

"info" command results

Local>info
TOWNET SPPOE5  SW Ver: 910508  HW ver: POE00103  POE ID:15999 (0x3e7f)
SETUP:
PoE output voltage: 24.0 V
PoE output current: 1.200 A
PoE Pwr jumper on 24V (fixed value)
PoE load On
PoE load present
Battery capacity: 24.0 Ah
Battery recharge: ON
Battery type: Pb_AGM
Battery in recharge at constant current
VDC=0.0V VAC=25.22V VPOE=24.42V IPOE=220mA VB=14.81V IB=234mA
Local>

current PoE configuration

The first row identifies main parameters of twidunode2, such as firmware version, hardware revision, unique ID in deciaml and hexadecimal format (between parenthesis).

The second row identifies SETUP parameters of twidunode2:

PoE output voltage: 24.0 V

It indicates the Output PoE voltage setted.

Icon-note.png

Note: Command answer depends on jumper tensione POE voltage jumper. If the jumper is located on 24V position, It is not possible to modify this value over 24V. Jumper status is reported on fifth row concerning info parameters


The fourth row indicates maximum output PoE current setted.

PoE output current: 1.200 A

With this setting, PoE injector supplies 1,2A and it rapresents default setting.

This parameter is useful in order to avoid absorption drift in case of devices fault.

PoE Pwr jumper on 24V (fixed value)

It states jumper tensione POE Voltage status status (jumper is located on the front side of twidunode2)

PoE load On

It states PoE supply voltage is available.

PoE load present

It states load-PoE connection is active and Load absorption.

current battery configuration

Battery capacity: 24.0 Ah

It indicates battery capacity setted. It is possible to set up battery capacity within 7Ah-26Ah range by means the following command:

set battcap [7000..26000]

Battery recharge: ON

It indicates battery charger status.It is possible to activate/deactivate recharging status with the following command:

set recharge [on | off]
Battery type: Pb_AGM

It indicates setted battery type. This parameter affects charging curve typology. Charging curve availability depends on firmware version uploaded. Newer versions can release more charging curves. For deep insghts concerning battery managementplease consider the following chapter: Battery settings.


Battery in recharge at constant current

It states current battery recharge status

Currents and Voltages status string

VDC=0.0V VAC=25.22V VPOE=24.42V IPOE=220mA VB=14.81V IB=234mA

This row summarizes all current and voltage measures performed by twidunode2.

identifier description
VDC=0.0V DC-IN input voltage
VAC=25.22V AC/DC input voltage (220V)
VPOE=24.42V PoE output voltage
IPOE=220mA PoE absorbed current
VB=14.81V battery voltage
IB=234mA Battery Current. If the value exhbits (+) symbol the battery is in charging status, meanwhile It exhibits (-) the battery supply voltage to twidunode2.